![]() ![]() Once it is connected directly, try to go through this procedure again.Īnother option is to try a quick zero-fill from the main menu and then to try a "C - Set Capacity" again. If the drive is on a controller card then it is possible that the set drive size command may not work. Make sure the drive is connected directly to the motherboard and not to a third-party controller card. If a message in red displays, then an error occurred. Remove the SeaTools diskette/CD, power off the computer for a few seconds, then reboot and check the capacity of the drive again in the BIOS. If you get an OK message in white in the middle of the screen, then the process was successful. Click the "R - Reset to Maximum" button.Click "C - Set Capacity" at the top of the screen.If this is not the current drive, click the "D - Drive" button in the upper left until you see the drive you want to test displayed in the middle of the screen. The model number of the drive currently selected is displayed here. You can see what device is selected by looking in the middle of the screen. Look at the bottom portion of the window to see what drives are listed and what device number they are. Now choose the drive for which to set the size.Tip: You can also right-click the target disk and then select Surface Test from the pop-up menu. Step 2: Select your Seagate hard drive and click Surface Test from the left action panel. Click "I agree" to the license agreement. Step 1: Click the MiniTool Partition Wizard icon on desktop to launch the application.Once booted from the SeaTools for DOS diskette or CD, the computer should display a screen with a license agreement. 137GB or 32GB) and it is a computer that should support a drive that large, then this would be a time to set the drive size. For example, if the drive is showing up as a smaller capacity in the BIOS (i.e. Once it is connected directly, try to go through this procedure again.Īnother option is to try a quick zero-fill from the main menu and then to try a "C - Set Capacity" again.Sometimes it is necessary to use the SeaTools for DOS software to get the drive back to its native capacity. ![]() There are ways to get around this problem, but since these Operating Systems are rather rare nowadays, I do not see the point of writing. The best bet to fix it is to change it back to 512B sector size using the same command setSectorSize option, but specifying 512 instead of 4096. Windows 2000, 2003 and XP do not support big drives by default you will have to install the latest service pack in order to get big drives working properly on these OS. I use Ubuntu 20.04 as well for most of the development on our Linux tools. Click "C - Set Capacity" at the top of the screen. I recommend contacting Seagates customer support to see if there is anything that can be done to assist you. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |